Mitsubishi Triton 2009-2012 MN [GLX-R]

Headunit Installation Requirements

You will need

Facia - Single DIN : 


Facia - Double DIN: 


Steering Wheel Control Harness: 

Required, also requires radio brand specific patch lead

Primary Harness: 

Required, may require a secondary harness

Antenna Adaptor: 

Not Required

Additional Products

T Harness (for adding aftermarket bluetooth car kits): 

About this Vehicle


Aug 2009 through Nov 2012


  • Mitsubishi



Chassis Type: 

  • 4x4
  • Ute

Place of Origin: 



  • GLX-R
  • Triton
  • MN
  • Mitsubishi

Mitsubishi Triton MN [GLX-R]

Up to 2012, the GLX-R Series Triton featured a Mitsubishi single DIN Radio (W697) with a red vehicle display.

The display can be replaced with a single or double DIN radio and relocated to the factory radio position using the FP9013K install kit

For Vehicles with the MMCS and Mitsubishi power sound a facia is not required, just a trim for the aftermarket unit. The APP0111 will suit for power only

Power Sound Speaker System
Front doors 2 way components (actively powered off the amplifier) 2 Ohm woofers (tweeter impedance unknown)
Rear doors 2 way coaxial speakers 2 Ohm speakers
Primary Harness: APP0111 (Useful for Power wires only, Speakers leads can not be used)
Speaker Spacers: APS311
Speaker Leads: APS32 (Woofers only)

Amplifier Wiring:
Front Left Tweeter + White/Blue - Black/Blue
Front Right Tweeter + White/Red - Black/Red
Located in smaller plug

Front Left Woofer + Red/Yellow - Black/White
Front Right Woofer + Green/White - Green/Black
Located in Larger Plug

Rear Speakers (Both the Same) + Yellow/Blue - Grey/Blue
Located in Larger Plug