Jeep Wrangler 2007- 2015

Headunit Installation Requirements

You will need

Facia - Single DIN : 

Required

Facia - Double DIN: 

Required

Steering Wheel Control Harness: 

Required, also requires radio brand specific patch lead

Primary Harness: 

Required, may require a secondary harness

Antenna Adaptor: 

Required

Additional Products

Antenna: 

Not Available

T Harness (for adding aftermarket bluetooth car kits): 

Available
Images
About this Vehicle

Dates: 

Jul 2007 & Onwards

Manufacturer: 

Sub-Model: 

JK

Chassis Type: 

Place of Origin: 

America

Manufacturer Website: 

Tags: 

Jeep Wrangler JK

The 2007 model year brought a complete redesign of the Jeep Wrangler, and also a four-door model. The TJ chassis was replaced by an all new JK platform. This next-generation Wrangler was noticeably wider than the previous model, with a 3.4-inch (86 mm) wider track; and though the two-door model has a 2-inch (51 mm) longer wheelbase, it is actually 2.5 inches (64 mm) shorter in overall length than the TJ, allowing for a 44.3-degree approach angle and a 40.4-degree departure angle.[23] With a larger factory available tire size of 32 inches, the breakover angle on the Rubicon is increased from 22.6° to 25.4°.

Information provided by: http://en.wikipedia.org/wiki/Jeep_Wrangler

Wiring Information

These vehicles do not have a switched 12v accessories wire in the factory harness. You will need to locate an accessories feed in the fuse box and wire up to the red wire in the APP018.
This does not retain factory amplifiers.

Speaker Cavities
Front: 6.5
Rear: 6.5