Mazda BT-50 2012-2018

Headunit Installation Requirements

You will need

Facia - Single DIN : 


Facia - Double DIN: 


Steering Wheel Control Harness: 

Required, also requires radio brand specific patch lead

Primary Harness: 

Required, may require a secondary harness

Antenna Adaptor: 


Additional Products

T Harness (for adding aftermarket bluetooth car kits): 

About this Vehicle


Jan 2012 through Mar 2018


  • Mazda

Chassis Type: 

  • 4x4
  • Ute

Place of Origin: 



  • Ute
  • 4x4
  • Mazda. BT-50

Mazda BT-50

A full model change of Mazda BT-50 was revealed on October 2010 at the Australian International Motor Show. It is based on the Ford Ranger (T6).

While the BT-50 version was designed by a Mazda team based at Ford Australia's design center in Melbourne, both Ford and Mazda worked independently. Of the exterior panels, only the windscreen, roof and rear screen are common between the Ranger and BT-50, although the underpinnings are largely the same. Mazda BT 50 is produced in Thailand and South Africa.

Information provided by:

Installation note: Before removing factory unit, switch car on, manually switch off factory radio and then remove. This will stop top display flashing and looking for a radio station once new unit is installed.